New Home Sewing Machine Manual9/19/2020
All artwork is original, however for clarity some of the overlaid lettering has been replaced with clearer versions.No changes were made to the actual letters and numbers referenced in the document.BLUE - NEUTRAL. BROWN - LIVE.
![]() As the colours of the mains lead of the appliance may not correspond with the coloured markings identifying the terminals in your plug. Thread tension regulator Top cover thread guide and Tension bracket 19. Open the slide plate in the bed of the machine so that the bobbin case can be reached. Insert the thumb and forefinger to open the latch and withdraw the bobbin case. Then push the bobbin winding spindle so that the latch fits into the bobbin. Fig. 1) 3. When the bobbin is wound excessively on the upper part of the bobbin (A), loosen the top cover thread guide set screw on the front of the top cover and lower the thread guide slightly. Hold the bobbin case by the latch and place it on the centre post with the bobbin case finger in the notch at the top of the shuttle. Release the latch and press the bobbin case into the shuttle until the latch catches on the centre post with a click. Pass the thread through upper arm thread guide (1), downwards around tension discs (2) from right to left, up over the tension thread guard (3) from behind, through the loop of the take-up spring (4), up and through the hole in the take-up lever (5), down through thread guides (67) and into the thread guide (8). To increase the tension, tighten the screw slightly with a small driver. TO USE BUILT- IN SEWLIGHT Sewlight is connected directly to the main supply lead of the machine when the motor plug is inserted into the connector. For sewing thin or light fabrics, press the top of the A pressure regulator (B) down lightly to get the required slight pressure of the fabric. Make sure the presser foot is for straight By moving this control knob gradually to the left toward sewing. Set the stitch length regulator knob to obtain close stitches (satin stitch). Mark with a pencil or chalk the position and exact length of the buttonhole on the fabric. Lower the presser foot and commence sewing the left row of the buttonhole until it reaches the end of the marking. Stop the machine with needle on fabric at point A. Lift the presser foot and using the needle as a pivot, turn the fabric end for end to bring the buttonhole to position (2). Then lower the presser bar lifter to ensure the thread tension device is set correctly. Embroidery will be done most successfully when the fabric is stretched and fixed in an embroidery hoop. Raise the presser bar, remove the regular presser foot, and attach a hemmer foot. Fold over the edge of the fabric approximately 18 inch wide, then fold it over again In the same way for a length of about 2 inches. Remove the regular presser foot and attach the zipper foot to the presser bar of the machine. First open out the zipper and place fabric 111 the position under the needle. With the button sewing tool In a raised position, place a button on the fabric with its holes in a horizontal line and the left side hole underneath the needle, and lower the fool upon it.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |